<TABLE BORDER=0 ALIGN=CENTER WIDTH=85%><TR><TD><font size=-1>Quote:</font><HR></TD></TR><TR><TD><FONT SIZE=-1><BLOCKQUOTE>
On 2004-09-14 17:58, ZRX61 wrote:
Got the duff axle shaft back, the only marking on it is "COAW" at the wheel end.
Bearing ID is 1 3/8
Bearing OD is 2 3/4 (or damn near, brake plate was flapping about in the way).
So, can anyone ID the axle shaft from the COAW?
</BLOCKQUOTE></FONT></TD></TR><TR><TD><HR></TD></TR></TABLE>

The bearing for my rearend is 3" across outside and 2 1/2" inside across center hole. If that helps any. I just measured the spare bearing I bought a couple years ago and haven't gotten put on yet. Not sure what the 8.5 has for axle size or anything though.