My Combo as follows

Roush 200 heads milled to 61cc
kb popups equal 10.4 to 1 (cced no guessing)
E303 roller cam(soon to be upgraded to comp cam 274 roller)
Rear wheels puttin down 282hp
I typically run 3.80s gears
3200 stall from coan

12.40s in the quarter in street trim.

Slicks cut of another .3

have ran a personal best 11.87 while borrowing a 50hp NOS
and slicks

I plan on being in the mid 11s or lower this spring with the cam and carb matching and if need be some 4.11 gears.
I have never dropped the exhaust either, to lazy maybe low 11s are possible.

IMO Gears and comp ratio are important and a good stall when running bigger heads on small displacements. Helps with the soggy bottom end. Light weight cars suffer less from this but still........

My temp never exceeds 195. I have a edelbrock water pump, griffin aluminum Rad and Mr gasket electric fan.

Timing is mechanical advance MSD distributor 34 Degree total all in by 2500rpm

Crane Ignition box with Rev Limiter set to 6400 rpm
Car weighs 2750lb with me in it(close guess)
Good Luck

<font size=-1>[ This Message was edited by: 1badmav on 11/29/04 12:41pm ]</font>