I worked on it over a couple of days ... could probably do one in half a day now ... If I had all the parts gathered up ahead of time.

Requires ... die grinder ... wire feed ... some scrap sheet metal ... air grinder ... a little bondo ... sandpaper ... hand saw ... screws ... air cleaner assembly ... two matching snorkles ... flex tubing and about six or seven sections of the 3.5" ducting (these ducts are curved and sleeved so you can fabricate them together and make them run any direction and distance you want)

I also vented the crank case to the air cleaner assembly so that took some fabrication as well.

It was a project but if you have the tools at your disposal and the inginuity to figure it out as you go ... It's very do-able [img]/phpBB/images/smiles/icon_smile.gif[/img]
[addsig]