ROUSH 200 HEADS??!!!

Does anyone know if the Roush 200 Heads have fixed their core shift problem discussed in the tech page on this website. I REALLY NEED SOME FEEDBACK. WORLD PRODUCTS WONT TELL ME JACK ****!!! ALL THEIR TECH GUYS ARE SORT OF.........STUPID.......Thanx alot guys.

Rich

I don't really think the people at World Products are dumb, they probably just don't want to answer your question. Their lack of response seems to say volumes(to me anyways). This is a subject that I've seen a fair amount of, Edelbrock Alum FE heads for a customers Thunderbolt 427(clone)had core shift and casting flash to beat all hell(one head did,the other was not as bad). But what do you expect for a mere $1200.00 for bare castings(joke)? I think it is something that is somewhat common, perhaps it's their way of trying to upsale to a full cnc'd set of heads.Check out Brodix ST 5.0 heads they flow 241 I and 184 E cfm at .600 valve lift out of the box,AFR is a good way to go also. These manufact. cost more, but the old addage applies-you get what you pay for...Good luck