shaft rockers

CHP has a set for $499.they are overkill for my set up. But a good set of shaft mounted and a girdle would be getting up there to,but not that high.got the block decked and clearanced today,so I am gona need them pretty quick. What would you guys do?...thanks
[addsig]

I think it over kill Doug. You are going with the big stroker cant see you spinning it that high to utilize them, Just my two cents.
[addsig]

A buddy of mine used a set of CHP (Probe) shaft units on a set of Edelbrock Victor Race heads with an aggressive roller, and they fell apart and the little roller bearings went everywhere!

He sent them back and purchased a 'good' set.

This is a 8000rpm beast that eventually ran 5.3's in the 1/8, but he had no troubles after installing the good ones. I believe they were Jessel. It didn't take any time for the Probe units he purchased from CHP to fail. However, they were good about taking them back. Luckily, it was noticed before any engine damage was done.

Good Luck!
[addsig]

CHP/Probe stuff is worse quality than Tiawanese! I don't think you need the shaft rockers either[img]/phpBB/images/smiles/icon_biggrin.gif[/img]
[addsig]

Overkill.........................

Ed

[img]/phpBB/images/smiles/icon_wink.gif[/img]

what I thought to,but needed somebody else to tell me I didnt need em.[img]/phpBB/images/smiles/icon_lol.gif[/img] Thanks guys