gt40\'s or 40p\'s ?

i'm slowly gathering parts for the el cheapo motor for the notch. both of theese heads are pretty inexpensive and easy to find. what one is the better bang for the buck?
[addsig]

i'd say regular gt-40's cause you dont have to pop for special headers as you would with the P's

my first set of heads were a set of gt-40's milled 040. and with a home port job i did, matched the intake to a 1250 felpro and removed the thermactor bumps on the exhaust and cleaned it up, i had them on a 302 with a 510/534 cam, intake and roller rockers and the car picked up about 3mph
[addsig]

I would use either one
[addsig]

I have P's on mine, using the same 302 headers I've always had. Did have to use Accel shorty spark plugs and 90* terminals and boots as used on an electronic distributor cap for the plug end of the wires. The short plugs were only needed on the driver's side.

<font size=-1>[ This Message was edited by: bmcd66250 on 4/1/05 11:47pm ]</font>