Looking for drawing of bellhousing bolt pattern

**Mario428** · 10-04-2007, 07:41 AM

Putting motor plates in my brothers Falcon this winter and would like to cut the midplate on my laser.
Wondered if anyone knew where I could get drawing of the bellhousing pattern for a small block.
I thought it used to be in the Motorsport catalog but not in any I can find.
Water pump pattern would be cool if anyone has that too for front plate

**Mario428** · 10-04-2007, 12:46 PM

Got one, as soon as I get the starter holes in it I will share

**pedal2themetal45** · 10-04-2007, 01:20 PM

Can't you just trace around the one he has??

**BrianS** · 10-04-2007, 04:14 PM

I can scan the images from an '86 Motorsport Catalog if you still need them.

**Mario428** · 10-05-2007, 04:12 AM

Quote:

Originally Posted by BrianS

I can scan the images from an '86 Motorsport Catalog if you still need them.

Yes please, email to mario428@eastlink.ca, would be much appreciated.
Scan at as high a resolution as you can, will allow me to check the info I got so far.
Thanks very much.

**BrianS** · 10-06-2007, 09:11 PM

In case anyone else was interested.

**72pintoken** · 02-02-2008, 12:27 PM

Thanks BrianS

**Mario428** · 02-03-2008, 07:50 AM

Since the topic came up again I will add I have my brothers block plate here and I will be finding the location of the starter holes so I can cut a midplate.
I will post results when I have them but I only have the small blockplate, need to do some measuring on the big one too at some point.



All content © FordMuscle, LLC. \| Ford® is a registered trademark of the Ford Motor Company. \| FordMuscle.com is not affiliated with the Ford Motor Company.