1963 Ford Fairlane Wheel Wells

**GlassPacks** · 08-09-2005, 11:20 AM

Hi Everyone,

A few months ago I purchased a 1963 Ford Fairlane 2-door sedan from an auction in Southern Ontario (Canada). It was stored in a barn for 25 years and fairly solid. The only area on the car that needed metal replacement was the driver's side lower quarter panel and the driver's side (rear) wheel well. So far the rust on the quarter panel has been cut out, the new lower quarter panel is ready to go in, and all I need now is to repair/replace the wheel well. Would it be best to buy a used one and cut out the area I need, or should I have a panel made by a fabricator, or should I try to make it myself? If anyone has a good driver's side wheel well they are willing to part with, please let me know.

Tom - Glass_Packs(at)yahoo.ca

**highpockets** · 08-11-2005, 01:04 AM

I dont have a wheel well for ya,but welcome to the board. I say if you think you can fix it yourself then go for it.
[addsig]



All content © FordMuscle, LLC. \| Ford® is a registered trademark of the Ford Motor Company. \| FordMuscle.com is not affiliated with the Ford Motor Company.