Need info in how to...

67 Conv. Galaxie 390. Please, need to know how to place front side 390 emblems if possible, without taken apart the front fender, in all forum pics, the emblems looks that they go more forward than in the middle...but...there is the problem noway I can get from under, top or side way, to properly place'em. My Dearborn emblems came each with four pins, guessing I will have to drill, or should I use both side sticky tape ? and cut out the pins...

dont cut the pins -- the pins go into holes in the fender -theres a little barrel clip that goes into the hole then the emblem pins go into the barrel clips--
you can find the barrel clips in the 2008 dearborn classics catalog on page 210 - upper right hand corner--

barrel clips are available at napa balkamp#665-1915

Rich, my car does not have holes...the prior owner bonded and painted the whole fender, so I dont know where they (emblems) go, I also have the clips, - the emblems came with them-, but my problem is that I have NO WAY sticking my arm inside, to secure the emblems via the clips...

the barrel clips go into the hole first-- then the emblem is pushed into the barrel cliups--you dont need to reach the back-- -

as far as where the holes need drilling -- look at a pic of a orig car

Thanks Rich, now I understand, at first did not look close enought into the barrels. Thanks again for your patience and have a great Thanksgiving Day.

As far as where they go, see your post from May.

http://www.fordmuscle.com/forums/gal...onv-500-a.html