What 2003 Mustang Front/Back seats look like in a 1991 5.0

Well, the back seats aren't quite done yet, but check it out:





They are Dark Charcoal thats why they look a little gray. But in person they are not bad at all!

<font size=-1>[ This Message was edited by: 66stang on 1/14/04 10:47am ]</font>

They look good in there!!! [img]/phpBB/images/smiles/icon_tup.gif[/img]
[addsig]

They look fantastic!
Any fab. work on the mounts?
[addsig]

Look good! [img]/phpBB/images/smiles/icon_tup.gif[/img]

Comfy too. [img]/phpBB/images/smiles/icon_wink.gif[/img]
[addsig]

<TABLE BORDER=0 ALIGN=CENTER WIDTH=85%><TR><TD><font size=-1>Quote:</font><HR></TD></TR><TR><TD><FONT SIZE=-1><BLOCKQUOTE>
On 2004-01-14 03:06, 85mike wrote:
They look fantastic!
Any fab. work on the mounts?

</BLOCKQUOTE></FONT></TD></TR><TR><TD><HR></TD></TR></TABLE>

Well, the front seats bolt right in. On the back's of the back seat what I did was use the 91 plastic plate, 2003 Foam, and 2003 Leather (obviously). The reason is the 91 Foam was a really odd shape and it didn't look right. On the bottom back, that is the actual 2003 Foam... I had to hack a lot of the foam out, and also I stood on the metal bars to smash them down a little so it would fit (using old seat as a guideline). All in all it fits good. The problem is the bottom doesn't snap down like the old ones, but I can fix it with a zip tie [img]/phpBB/images/smiles/icon_smile.gif[/img]

Chris

Zip ties are your friend.[img]/phpBB/images/smiles/icon_tup.gif[/img]
[addsig]