Hey Six Shooter guy\'s!

I need to mate this fully synchroed 3 speed to my 200 in my falcon... What application do I get the flywheel from?
I have the tranny and my small 3 spd disc don't fit it and the disc that does fit it is too big for my flywheel....

Vat Kan I Dooooo?


FE
[addsig]

What's the disc diameter and spline count of the trans?

It's got a 10 spline clutch disk that is sitting on it.

Are you on to something?
[addsig]

And it's a 9" slutch disc...
[addsig]

Hi Gary
I used a bell housing and clutch and tranny from a 72 mav. worked for me.. on my 200. I don't remember what I did for a fly wheel?? I know I didn't use the one off the stock 170cu. I'm sure I used one from a 200 I had sitting around.
go to the Ford Six site in the FAQ page there a link on bell housings.
Take Care
tim [img]/forums/images/smiles/icon_spin.gif[/img]
[addsig]

HHMMM
I just went to the tech pages and the link is screwed up I think it don't open up the right page???
Sorry Gary
Tim
[addsig]

I looked through there Tim and didn't find what I need.

Rayel has done it but he's probably out in his Garden... [img]/forums/images/smiles/icon_wink.gif[/img]

I have the bell to fit the full synch e spd. I have a disc. I don't have a pressure plate or a flywheel....

The diffrence in the stock non synch 3 speed and the full sync is the case is longer on the full and the tail is shorter, the non synch has a shorter case but longer tail, so overall they are the same length +- .5"

I didn't count the driveshaft splines though... I just want them to mate up to my 1970 engine.

FE

[addsig]

<TABLE BORDER=0 ALIGN=CENTER WIDTH=85%><TR><TD><font size=-1>Quote:</font><HR></TD></TR><TR><TD><FONT SIZE=-1><BLOCKQUOTE>
On 2007-04-09 15:14, FEandGoingBroke wrote:
It's got a 10 spline clutch disk that is sitting on it.

Are you on to something?

</BLOCKQUOTE></FONT></TD></TR><TR><TD><HR></TD></TR></TABLE>
Maybe. I will look in my book that I have.

It's a 10 spline, 9" disc that you need?

I'll let you know what I come up with.

Mike, I need a 10 spline 9" pressure plate, and a flywheel to match it. I have the clutch disc.

FE
[addsig]

<TABLE BORDER=0 ALIGN=CENTER WIDTH=85%><TR><TD><font size=-1>Quote:</font><HR></TD></TR><TR><TD><FONT SIZE=-1><BLOCKQUOTE>
On 2007-04-10 10:56, FEandGoingBroke wrote:
Mike, I need a 10 spline 9" pressure plate, and a flywheel to match it. I have the clutch disc.

FE

</BLOCKQUOTE></FONT></TD></TR><TR><TD><HR></TD></TR></TABLE>

Ok, let me see if I understand you correctly. You are looking for a flywheel and pressure plate to match up with a 9" clutch disc?
The flywheel needs to come from what year(s) of engine?
Have you called up your local wrecking yard and asked them to look in their Hollander Interchange book yet?