|
Yates heads on stroker
Yes his are the C3H heads. Same intake as well...351Y E-intake.
I ran into another guy yesterday that had a set of nascar take-offs that he got from Ebay. He had them on a alky-injected 362" windsor that ran some 5.70's in the 1/8 at 118. When I asked him who ported them, all he said was Keith Craft.
...And yet another friend has a set of C3Hs on a '86 coupe...380" windsor (4.155 bore 3.5" stroke)...lots of nitrous, 2 1/8" headers..yaddya yaddya, and runs some consistent 5.05 /138 in the 1/8 mile. Friend of his (don't know him personally) runs a '90 hatchback with a 101mm turbo with the EXACT same heads (same port program and all) and runs 4.80's when traction is good. I personally haven't seen it that fast, but I did see a on-and-off the throttle traction limited 5.12/144....so I don't doubt that it'll run sub 5 seconds.
Cams are all custom. When you get to the stage of using these heads, you are building a pretty serious engine....do yourself a favor and just order a custom camshaft that is specific for your head flow rate and engine combo.
[addsig]
|
Today
