Maverick with AOD. What headers?

<TABLE BORDER=0 ALIGN=CENTER WIDTH=85%><TR><TD><font size=-1>Quote:</font><HR></TD></TR><TR><TD><FONT SIZE=-1><BLOCKQUOTE>
On 2006-05-10 07:43, NMustang wrote:
Sorry they were dynomax not flowtechs. I got them from summit the summit part number is WLK-85112. if you going to run an AOD, you will need to modify the tranny linkage and also the bellhousing has a couple of casting horns on the side that will need to be trimmed, but not biggy, they don't hold anything. the header hits them just slightly, so you can either modify (hammer method) the tube or shave off those ears. your choice...

NMustang
</BLOCKQUOTE></FONT></TD></TR><TR><TD><HR></TD></TR></TABLE>

Thanks Nmustang
Did you have power steering and if so did you keep it?
I would start out with the C4. Do you think the same mods will be required?

Thanks
tim
[addsig]

tbirdsz12,

My maverick doesn't have power steering, however in looking at the summit website, it they list WLK-88303 which is a bracket to drop the end of the slave cylinder to use power steering with the headers. it looks similar to the one i have on my GTA, which works like a charm.

_________________
1967 Mustang GTA Coupe 351C
1967 Mustang FB
1975 Maverick 53k all original
1985 Bronco II 351W
1950 Ford F-1
2002 F-350 CC-PowerStroke 4x4 Dually

<font size=-1>[ This Message was edited by: NMustang on 5/12/06 9:22pm ]</font>