trickflow R heads

i am going to put r heads on a 408 the piston was not cut for these head has anyone cut the valve pockets while they were sill in the block
[addsig]

yes it can be done.....make sure u clean up the mess VERY well afterwards and do an oil change shortly after

is the motor out of the car?

<font size=-1>[ This Message was edited by: cazyhorse on 2/28/06 9:04am ]</font>

Yes its out i have found out that Isky cams make a tool that will grind the relief in the piston while still in block it fits where the valve are in the head

[addsig]

take your time
[addsig]