Network
Driver Sheetmetal-
Pete has started sheet metal work. Or should I say Sheet metal Artwork!
The floor section under the seat is aluminum. The seat is mounted to the cage, no worries there. The lower back sheetmetal piece rolls over the main hoop. The back piece of aluminum rolls out toward the hoop and both pieces will be joined to the main hoop. The very back piece of aluminum also lips up over at the top edge where the window goes in. The rubber seal of the window will cover the top edge of the aluminum.
The front floor section is steel. Beads were put into the floor for rigidity and prevent the floor from tin canning when I step in with body weight. The hole is where the Master reservoir will come up through the floor.(You can see the EASY BUTTON on the dash!)
The small oval hole towards the front is where the brake pedal comes up through the floor.
This is very cool! This Piece was bent one section at a time to form this funnel.
This funnel will allow the extra room needed to exit exhaust pipes out through the fenderwell!
