In this shot, you’ll see the 4 holes needed for the A/C and heater hoses to enter the firewall. I’ll install the required AN male to male fittings in all these holes during installation.

I’m completing fabricaciton of the P/S and Oil coolers mounting points. This ended up being a perfect place for the mounting as it doesn’t interfer with air flow to the radiator and is just behind the opening in the front valance, under the bumper.

I filled the front and rear side light openings for the clean look. I also filled the antenna opening on top of the front left fender.

To help prepare for the “finished” engine bay, I fabricated a flat firewall. You might recall from an earlier post, the firewall had to be removed to allow room for the engine. The the car is at body and paint, all seams and ribs will be filled and smoothed. The engine bay will be the car’s exterior color.